TENS UNITS

• Single Mode
• 3 Mode 
• 3 Mode with Timer 
• SD TENS 
• LCD TENS
• Micro Current 
• Electrodes

EMS UNITS

• Portable EMS

• Portable EMS w/AC

• 4 Channel EMS

• LCD EMS

• Interferential Stimulator

• Galvanic Stimulator

• Accessories

Phone (800) 981-7345

  Fax (585) 486-6067

• Home

• Contact Us

LCD EMS

Technical Specifications

Channel:  dual, isolated between channels

Output waveform:  asymmetric square pulse

Amplitude:  adjustable 0-80 MA, peak @ 500 ohm each channel

Pulse Rate:  adjustable 2-120 Hz

Pulse Width:  adjustable 50-260 us

Cycle on Time:  adjustable 1-30 seconds

Cycle off Time:  adjustable 1-45 seconds

Mode:  Synchronous, Constant and Alternate

Battery:  one 9 volt

Size:  59(L) x 100(H) x 24(W) mm

Mode Functions

Synchronous (S) -  The pulses of Channel 1 and Channel 2 are synchronous.  While Channel 1 is activated, Channel 2 will be activated simultaneously.  The pulses active and inactive duration is controlled by ON TIME and OFF TIME.

Constant (C) - Both Channel 1 and Channel 2 are continuous pulses under an adjustable pulse rate.  The functions of ON TIME, OFF TIME and RAMP are all disabled.

Alternate (A) - The pulses of Channel 1 and Channel 2 are Alternative.  When Channel 1 is activated, Channel 2 will be inactivated and vice versa. 

LCD Screen

This LCD will be utilized to display stimulating mode/ pulse width/ pulse rate and to display the timer.  The channel output will be indicated on the top of the LCD screen.  The distinction of the modes will be showed on the top of the LCD panel.  The pulse rate and width will be showed on the middle of the screen.  The timer and clock symbol is showed on the bottom of the screen, the symbol will be twinkled until the final 5 min.